Hook up kirby shampoo attachment

hook up kirby shampoo attachment

How do you use a Kirby Tech drive vacuum?

Easily move the Kirby system while vacuuming, shampooing carpet or scrubbing hard floors. Put the Tech Drive in neutral by pressing down on the side of the pedal marked “N”. The unit will move easily in neutral when turned off. Polishing hardwood floors with Miracle Shine High Gloss Floor Finish

How do you use the belt lifter on a Kirby power washer?

While you are pushing up on the belt with your finger, use the handle on the belt lifter to turn it counterclockwise until the red arrows line up. The belt lifter hook will catch and stretch belt. Install the Power Nozzle back on the Kirby system and rotate the belt lifter until the green arrows line up.

How do you put a turbo on a Kirby Sander?

On a level surface, reattach the sander dust shroud with the opening to the back, and insert the hose. Hold the turbo accessory at the top and bottom and turn your Kirby on. Then turn the turbo accessory on.

How do I attach the disposable filter bag to the adaptor?

Then, rest the cardboard faceplate of the disposable filter bag against the bottom of the adaptor. Pivot the faceplate against the flat surface of the adaptor and bend and press the tab at the top of the faceplate until it’s secure. The bag support strap should be connected through the small hole on the adaptor, which is over the stud.

How do you use Kirby Tech drive power assist?

First turn the Tech Drive Power Assist on by pressing down on the side of the pedal marked as “D” for drive. This makes it easy to use while operating the unit. Easily move the Kirby system while vacuuming, shampooing carpet or scrubbing hard floors.

How do I use Tech drive power assist on my vacuum?

Bend the the outer bag in half and insert the bag latch tab into the slot of the handle with the zipper facing up. Tech Drive Power Assist will make it easy to push and pull the vacuum when in use. First turn the Tech Drive Power Assist on by pressing down on the side of the pedal marked as “D” for drive.

How do you put a turbo on a Kirby Sander?

On a level surface, reattach the sander dust shroud with the opening to the back, and insert the hose. Hold the turbo accessory at the top and bottom and turn your Kirby on. Then turn the turbo accessory on.

How do you use the belt lifter on a Kirby power washer?

While you are pushing up on the belt with your finger, use the handle on the belt lifter to turn it counterclockwise until the red arrows line up. The belt lifter hook will catch and stretch belt. Install the Power Nozzle back on the Kirby system and rotate the belt lifter until the green arrows line up.

Related posts: