Cb radio antenna hook up

cb radio antenna hook up

How to install a CB radio antenna?

To complete your antenna installation, you need to do a CB radio setup, and the logical first step is to use an SWR meter. An SWR meter, whether built-in or in a separate unit, will also help you determine where to mount your antenna.

How to connect a CB microphone to a car radio?

Simply put, you are going to have to connect your coax to the antenna by running the CB coax cable all the way from the antenna to the radio. The next task is to connect your CB mic. After this is done, you have to power the radio. Powering the radio can be done in a few ways.

Are CB antennas plug and play?

CB antennas are not plug and play. CB radio antennas must be SWR tuned to the vehicle and the final antenna location on the vehicle. When adjusting SWR, close the doors on the vehicle to get the most accurate adjustment.

What size coax do I need for a CB antenna?

For Dual or co-phase installations, use 72-75 ohm (RG-59A/U) coax. CB antennas are not plug and play. CB radio antennas must be SWR tuned to the vehicle and the final antenna location on the vehicle. When adjusting SWR, close the doors on the vehicle to get the most accurate adjustment.

Can You mount a CB radio on an antenna?

Both single mounts (for CB radios only) and double mounts (for AM/FM radios as well as CB radios) are available. Also, a lot of people seem to like the hump mounts. After youve installed your CB radio, its time to add the antenna to the system.

What should I do after Ive installed my CB radio?

After youve installed your CB radio, its time to add the antenna to the system. IMPORTANT: Do not key your mic before the antenna is installed! If you do, you risk damaging or destroying your radio! Youll find a great selection of antennas on our mobile antennas page.

How to wire a CB radio?

Now, how to wire a CB radio - that means that youll need to run your coaxial cable from the antenna to the CB radio plus provide a source of power to run the radio. How youll do that depends on your vehicle. You may need to run cable from the trunk lid through the back seat, then under the doorframe and window pillar or the dash and firewall.

How long should a CB antenna be?

In theory, the best CB antenna is 102 inches long, mounted in the middle of a large, flat, metal surface, properly grounded, sturdily mounted and has the shortest, straightest coaxial cable connecting it to the CB radio.

Is CB CB coax cable necessary?

CB coax cable is necessary to connect your antenna to your radio. The coaxial cable running from your radio to the antenna is VERY important. Everything you transmit and receive must travel along its length. All too often, the coax is ignored and performance suffers because of the lack of attention it receives.

How much coax do I need for an antenna?

Select the correct coax length. Many antenna manufacturers somewhat pre-tune the antennas utilizing 18 feet of coax which is why we generally recommend 18 feet of coax even if you dont think that you need that much.

What size CB antenna do I Need?

When it comes to all CB antennas there is a general rule, the bigger the antenna, the better the performance. However most people dont want a 9 foot antenna on top of their vehicle!

What type of coaxial cable is used for antenna installation?

RG-58 type coax is 50 ohm cable and is used for single antenna installations of CB, scanner, 2-meter, and 10-meter Firestik antennas. RG-8 and RG-8X are other common coax types that can be used on single antenna installations.

Related posts: